Cuisinart Cook and Hold Instructions d'exploitation télécharger pdf (Page 8)

8. To clean the

pressure limit

valve, remove

and rinse it with

water, then

replace it

(figure 9).

9. To clean the condensation collector,

remove and clean it with warm soapy

water, then reinstall it.

Symptom Possible Reasons Solutions

Lid does not lock

The ring is not properly installed Reinstall the ring

The float is seized by the push rod Push the rod with

hands

Cannot open the lid after air

exhaust

The float is still up Press the float down

Air escapes from the rim of the lid

No sealing ring was installed Install the sealing ring

Food residue on sealing ring Clean sealing ring

Sealing ring worn out Replace the sealing

ring

Lid not locked properly Rotate lid fully

Air escapes from the float valve

Food stuck on the sealing ring of

the float valve

Clean the sealing ring

The sealing ring on the float

wore out

Replace the sealing

ring

The float will not rise

The pressure limit valve is not

placed properly

Place the device to

Pressure .

Not enough food and water Check recipe for

proper quantity

Air escaping from the rim of the lid

and the pressure limit valve

Call our Consumer

Service Centre toll

free at 1800 808 971

(AUST), 0800 435 000

(NZ)

Unit shuts off when START is

pressed to begin Pressure Cooking.

Browning function was just

used and temperature in unit is

higher than Pressure Cooking

temperature, so safety shutoff

occurs.

After Browning, let

unit cool down for 2

or 3 minutes before

you start Pressure

Cooking.

TROUBLESHOOTING

1 2 3 4 5 6 7 8 9

Commentaires sur ces manuels

Pas de commentaire

Cuisinart Cook and Hold Instructions d'exploitation Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Petits appareils de cuisine Cuisinart Cook and Hold